Electric plastic potentiometer sensor precautions

　　1. After the sensor leaves the factory, the product is disassembled and modified by the user (including tearing off the trademark, processing on the shaft and housing, loosening the screw, rotating the position of the fixed ring, etc.), the manufacturer is not responsible for the warranty service.

　　2, when the sensor is connected to the line, it is strictly prohibited to connect the wrong leading end, pay special attention to the brush leading end (2#), and cannot access the input voltage.

　　3, when the sensor is energized, pay attention to the precision conductive plastic potentiometer, and use the resistance and current files of the multimeter to measure the sensor voltage.

　　4, the sensor should not be thrown during the installation process, so as not to damage the leading end.

　　5, the sensor in the applied voltage should be guaranteed within the rated power consumption range. (Note here that rated power consumption refers to the allowable power consumption of the sensor at the ambient temperature of 70 ° C, and the power use should be reduced when it exceeds 70 ° C).

Read recommendations:

combining rf signals

frf filter

VHF broadband transmitting system

Main characteristics of electric plastic potentiometer sensors

RF isolator type