Potentiometer with switch and its function and structure characteristics

　　Potentiometer with switch is a kind of variable resistor. It is usually composed of a resistance body and a rotating or sliding system, that is, a moving contact moves on the resistance body to obtain part of the voltage output.

　　The role of a switching potentiometer - regulating the voltage (including DC voltage and signal voltage) and the size of the current.

　　The resistance body with the switching potentiometer has two fixed ends, and by manually adjusting the rotating shaft or sliding handle, changing the position of the moving contact on the resistance body, the resistance value between the moving contact and any fixed end is changed, thus changing the size of the voltage and current.

　　The unit of resistance is: ohms, unit symbol Ω, in the circuit, the resistance is represented by R, and the potentiometer with a switch is represented by VR

　　The unit of resistance: milliohm Ω (m), ohm (Ω), qian Ω (k), megohm Ω (m), geovax, Ω (G) too (T Ω)

　　Their conversion is in thousands: 1 MΩ =1000KΩ 1 kω =1000 Ω

　　Common units are: Ω, KΩ, MΩ, other milliohm. Gio. Tayo are not commonly used, reading, writing, marking, usually remove the M word of ohms, directly read how many ohms

　　In the resistance chip product labeling, our company has two kinds of labeling:

　　One: for example, B500 B1K A50K C10K, etc., the resistance value is directly converted by adding ohms to the back,(A, B, C, D in front of the resistance type, independent of the resistance value)

　　Two kinds: For example: B102 B504 A103 C105, etc., the resistance value is followed by several corresponding "0", unified into ohms, B102 is B10+00= B1000 ohms

　　The main reason for the switching potentiometer with large rotation noise is due to the wear of the resistor, so that the contact between the moving plate and the resistor is poor, the resistance value is large and small, resulting in a "click, click" sound, the multimeter can be used to detect the above-mentioned method, you will find that the pointer has a jump phenomenon.

　　For the switch potentiometer with such a fault, the cleaning method can be used to eliminate the fault. That is, the cotton ball dipped in water-free alcohol with tweezers is placed close to the rotating shaft, so that the alcohol is injected into the resistor along the rotating shaft, and the rotating shaft is constantly turned until the noise disappears.

Read recommendations:

50 amp to 30 amp splitter

omnidirectional mimo antenna

ceramic rf filters

RF isolator directional and bidirectional coupler

Five steps to correctly select a power relay RF sensor