Time RF sensor main product technical parameters

　　1, the rated working voltage refers to the time RF sensor when the coil time RF sensor is working normally, the voltage required by the technical parameters. Depending on the type of time RF sensor, it can be AC voltage or DC voltage.

　　2, DC resistance

　　Refers to the DC resistance of the coil in the time RF sensor, which can be measured by a multimeter.

　　3, suction current

　　Refers to the time RF sensor can produce the minimum current of the suction action. In normal use, the given current must be slightly greater than the suction current, so that the time RF sensor can work stably. For the working voltage added to the coil, generally do not exceed 1.5 times the rated working voltage, otherwise it will produce a large current and burn the coil.

　　4. Release the current

　　Refers to the time RF sensor generates the maximum current of the release action. When the current of the time RF sensor is reduced to a certain extent, the time RF sensor will return to the unenergized release state. The current is much less than the suction current.

　　5, contact switching voltage and current

　　Refers to the time RF sensor is allowed to load the voltage and current. It determines the amount of voltage and current that the time RF sensor can control, and cannot exceed this value when used, otherwise it is easy to damage the contact of the time RF sensor.

Read recommendations:

50 amp to 30 amp splitter

catv trunk amplifier

qualcomm baw filter

Guatunable rf bandpass filter.rdians in the field of RF signal separator communication

best omni directional 4g antenna