Use method of portable oil-water interface instrument

　　1, instrument composition

　　The portable oil-water interface instrument consists of probe, cable and display. The probe has a float design, which helps us quickly distinguish the location of oil and water; The cable is used to transmit the data collected by the probe to the display; The display is used for data display and analysis.

　　2. Preparation before use

　　Before use, the power supply of the instrument should be filled and the initial charge should be carried out. After charging is complete, check that the connection between the cable and the display is strong, and ensure that the sensitive parts of the probe and the lead wire are intact.

　　3. Start using

　　Before starting to use the oil water interface instrument, stand the probe in clean water and press the switch to start it. When the value on the display is stable, you can use this data to adjust the separator.

　　The probe should be placed carefully. When dipping the probe into the liquid, the probe should remain stable so that it floats on the liquid surface. When you go to the site, you should first calibrate the probe into the environment. This process should be done before each use.

Read recommendations:

sma splitter combiner

omni antenna 2.4 ghz 20dbi

rf line isolator

cubesat uhf transceiver.There are three reasons why the receiver may be good or bad at work

rf splitters and combiners.Scope and characteristics of application of radio frequency admittance level gauge